#Elgato game capture hd software mac 720p#

The Elgato Game Capture HD60 has a delay of around 650ms. 1400ms is a good place to start, but I recommend testing to get more accurate.

In the Audio tab, set the last option 'Mic time offset' to 1400ms.

In Audio, select the speaker(Headphones) and microphone you will be using.

#Elgato game capture hd software mac 720p#

I personally recommend downscaling 1080p to 720p for increased quality and also its easier on your computer.

In the video settings, where it says 'Base resolution' set it to whatever the console resolution is set to(This will most likely be 1080p).

In the broadcast tab, For mode, choose 'live stream'.

You will need to do some tuning on your own. Please remember all systems and setups are different and the estimator is only that, to estimate. The settings you see are a baseline, but I recommend using the OBS Estimator, and then fine tuning your stream settings from that point on.

Name it whatever you would like, then click 'add'. If you have any questions or concerns, be sure to either ask in the resource discussion, ask me on Twitter, or ask in the OBS help forum.Д®lgato Video Capture Software DownloadIf you feel like your device might be having issues, please contact Elgato Support. Refer to this thread if you are getting 'Warning, taking to long to encode' messages, or this thread if your bit rate indicator is turning yellow or red. Note: Most of the settings like FPS, resolution and X264 preset can be changed and based on your computer, you will most likely need to change them.

Play a game of whatever you like to play to check for encoding issues listed below and to check for audio levels and quality.

Play around in the console menu, and you should see the left hand side audio bar move.

After a few moments, your console screen should appear.

Now turn on whatever console you will be streaming.

Mouse over 'Global source', and you should see the Game Capture HD(Or whatever you named it).

Name the scene 'Game Capture HD' so you know whats in the scene.

Right click in the scenes box, and choose 'Add scene'.

Now close the Game Capture HD settings screen.

In the video options, tick the checkmark that says 'Enable buffering' and set the buffering time to 1.

The Game Capture HD should be automatically selected at the top, if not, click on the dropdown menu and choose 'Elgato Game Capture HD'.

Name the source 'Elgato Game Capture HD' for easy remembering.

At the bottom right, click on 'Global sources'.

Once you have streamed for a bit, you can change these settings., however, set the 'Keyframe interval' to 2.

In the Advanced tab, leave most of the options the same.

Do some test streams to figure it out the best you can. You may need to adjust by +50 or -50ms, or even more.

You have installed the Game Capture HD software/drivers version 2.10.64+.

You have a Game Capture HD60 or HD from Elgato.

Please make sure you have done this before starting: